Administration

SIP Trunking between Nortel CS1000 and UCX

Overview

This page provides instructions on how to setup SIP Trunks between a E-Metrotel UCX Server and a Nortel CS1000.

NOTE

The Nortel/Avaya CS1000 product line is an extremely sophisticated family of products and requires proper training to operate correctly. This document assumes that there are trained technicians available to configure the CS1000 product. E-MetroTel cannot provide support for the CS1000.

This document is based on UCx Release 6.0 and CS1000E Release 7.65

On the Nortel CS1000

Configure the following:

  1. IP D-Channel [DCH 96]
  2. SIP Route [R96]
  3. RLB [RLI 104  E0:R96]
  4. CDP [DSC 69] → RLI [104]

On the NRS

Configure an Endpoint and a Route:

​Endpoint

  • Endpoint Name: ucx
  • Trust Node: Yes [checkbox]
  • Endpoint Authentication enabled: Authentication Off [Dropdown Menu]
  • Static endpoint address: 10.0.7.199 [ucx IP address]
  • SIP mode: Proxy Mode
  • SIP TCP Transport enabled: NO
  • SIP UDP Transport enabled: YES
  • SIP TLS Transport enabled: NO

​​Route

  • Endpoint Name: ucx
  • DN Type: Private Level 0 regional (CDP Steering Code)
  • DN prefix: 69 [ucx DN range]
  • Route Cost: 1

On the E-MetroTel UCX Server

On the UCX you will need to configure a SIP Trunk to the CS1000 IP Telephony Node and to the CS1000 Network Routing Service (using the IP Trunk Assistant), and then create a route for CS1000 CDP dialing

SIP Trunk to the CS1000 IP Telephony Node

  1. Navigate to the PBX-> IP Trunk Assistant page
  2. Click on the New Account link
    NewAcct_SIPTrunk.png
  3. Enter an Account Name: e.g. CS1000-Node
  4. Set the Trunk Provider to UCX
  5. Enter a Host / IP address using the IP address of the CS1000 IP Tel Node
  6. Enter a From Domain using the domain of the NRS
  7. All other fields should be left as defaults
    CS1000_SIPTrunk.png
  8. Click Save

SIP Trunk to the CS1000 IP Network Routing Service

  1. Add another SIP Trunk using New Account button.
  2. Enter an Account Name: eg. CS1000-NRS
  3. Set the Trunk Provider to UCX
  4. Enter a Host / IP address using the IP address of the CS1000 NRS TLAN
  5. Enter a From Domain using the domain of the NRS
  6. All other fields should be left as defaults
  7. NRS_SIPTrunk.png
  8. Click Save

Create a route for CS1000 CDP dialing

  1. Click on the Outbound Routes page on the PBX tab.
  2. Enter an Route Name (eg. CS1000)
  3. Add dial patterns that match the CDP plan of the CS1000 (eg. [2XXX,3XXX,4XXXX,5XXXX,6[1-8]XX,7XXX,8XXX])
  4. Configure the Trunk Sequence for Matched Routes:  Entry 0 using the name of the SIP Trunk account you created for the CS1000 IP Telephony Node (eg. CS1000-Node)

Contents