Administration

Configure Second Network Port
NOTE

The following assumes the first Network Interface is used for connecting the UCX to the internet, so no Default Gateway or DNS Server information is configured. If this second Network Interface is intended to be used for Internet connection, then it should be configured with all the parameters prior to configuring any information on the Ethernet 0 port.

Enable and configure the Second Network Interface Port and the DHCP Server on the UCX server for use as a Voice or Telephony LAN.

  1. Open UCX Administration
  2. From the System tab, select Network
  3. From the left side column, select Network Parameters
    NetworkParameters-R7
  4. Select the Ethernet_1 port and verify the Interface Type is Static, the IP address is 192.10.200 and Network Mask is 255.255.255.0.
    NetworkInterface1
  5. Press the Apply changes button if you made any changes. 
  6. From the left side column, select DHCP Server.
  7. Click the Edit link for Ethernet 1 interface.
  8. Configure the following fields:
    • Starting IP Address = 192.168.10.2
    • Ending IP Address = 192.168.10.127 (make sure the range does not include 200)
    • Lease Time = 1 day
    • Gateway = 192.168.10.200 (IP address of the UCX Server Ethernet_1 port) 
  9. Click the Save button.
    DHCP-Ethernet1
  10. Click the Start DHCP Server button to activate the DHCP server.
    DHCP-Inactive
  11. The DHCP Server status will now show Active.
    DHCP-Active

Network Diagram showing separate Voice LAN

Contents